Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM38G0E _58 Vehicle Interior _100628 SEAT _0467516 SEAT HEATER SYSTEM C

SEAT  SEAT HEATER SYSTEM  B14C211  Rear Right Seat Heat Sensor Circuit Short to Ground  B14C215  Rear Right Seat Heat Sensor Circuit Short to Battery or Open  


DESCRIPTION

Output to the rear No. 1 seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B14C211 Rear Right Seat Heat Sensor Circuit Short to Ground A short to ground in the temperature sensor circuit of the rear right seat heater occurs for 4 seconds or more.
·

Air conditioning amplifier assembly

·

Rear No. 1 seat cushion heater assembly RH

·

Harness or connector


Air Conditioner A
B14C215 Rear Right Seat Heat Sensor Circuit Short to Battery or Open A short to +B or open in the temperature sensor circuit of the rear right seat heater occurs for 4 seconds or more.
·

Air conditioning amplifier assembly

·

Rear No. 1 seat cushion heater assembly RH

·

Harness or connector


Air Conditioner A

WIRING DIAGRAM

E396781E26
0.948,1.969 2.51,2.563 1.563,0.594 10 false Air Conditioning Amplifier Assembly 4.188,1.969 6.24,2.458 2.052,0.49 10 false Rear No. 1 Seat Cushion Heater Assembly RH 2.208,0.948 2.729,1.156 0.521,0.208 10 false TFAR 2.219,1.479 2.729,1.708 0.51,0.229 10 false SG-7 2.688,0.813 2.958,0.969 0.271,0.156 10 false 5 0.979,1.771 1.375,2 0.396,0.229 10 false I30 2.688,1.396 2.958,1.552 0.271,0.156 10 false 3 4.198,1.771 4.563,2.042 0.365,0.271 10 false j2 4.271,0.771 4.448,0.969 0.177,0.198 10 false 6 4.281,1.365 4.49,1.583 0.208,0.219 10 false 7

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 450

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 450

Result:
Result Proceed to
B14C211 and B14C215 are not output A
B14C211 or B14C215 is output B



A

B

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY RH)
3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY RH)

Pre-procedure1

a.

Disconnect the I30 air conditioning amplifier assembly connectors.


b.

Disconnect the j2 rear No. 1 seat cushion heater assembly RH connector.


Procedure1

c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(I30,j2)Location & Routing

Click Connector(I30)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Air Conditioning Amplifier Assembly

Click Connector(j2)Seat>Rear Seat Wire RH>Rear Seat Cushion Heater RH (Rear No. 1 Seat Cushion Pad RH)

I30-5 (TFAR) - j2-6 Always Below 1 Ω
I30-5 (TFAR) or j2-6 - Other terminals and body ground Always 10 kΩ or higher
I30-3 (SG-7) - j2-7 Always Below 1 Ω
I30-3 (SG-7) or j2-7 - Other terminals and body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

d.

None



OK

4.INSPECT REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY RH

OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPLACE REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY RH