INITIAL POSITION MEMORIZATION
When the following actions are performed, initial position memorization is necessary:
The fold seat control ECU is replaced with a new one.
The fold seat control ECU initial position memory is reset.
When the ignition switch is turned to ON before performing initial position memorization, a buzzer sounds continuously while the ignition switch is ON. Once initial position memorization is complete, the buzzer stops.
Initial Position Memorization (for LH Seat)
Press and hold the LH seat return switch and move the seatback and seat cushion to the return end position.
Initial Position Memorization (for RH Seat)
Press and hold the RH seat return switch and move the seatback and seat cushion to the return end position.
INITIAL POSITION MEMORY RESET
When the following actions are performed, initial position memory reset is necessary:
The battery is disconnected while the seatback or seat cushion is moving.
The fold seat control ECU is replaced.
The seatback or seat cushion is moved while the fold seat control ECU is disconnected.
The relationship of the positions of the seatback and seat cushion becomes abnormal due to removal/installation, replacement, etc. of the seat.
Check that the vehicle is in the following condition.
Shift lever in P
Ignition switch is off
Rear power seat system is not operating
Fold switch or rear power seat switch is not being pressed
Back door is open
Initial Position Memory Reset (for LH Seat)
While pressing and holding the LH seat return switch in the fold seat switch assembly, press the LH seat fold switch in the No. 1 fold seat switch assembly or No. 2 fold seat switch assembly 5 times within 10 seconds.
Make sure to hold the return switch of the No. 1 fold seat switch assembly or No. 2 fold seat switch assembly until the reinitialization process complete buzzer sounds.
When the initial position memory reset is completed, a buzzer will sound 3 times.
Initial Position Memory Reset (for RH Seat)
While pressing and holding the RH seat return switch in the fold seat switch assembly, press the RH seat fold switch in the No. 1 fold seat switch assembly or No. 2 fold seat switch assembly 5 times within 10 seconds.
Make sure to hold the return switch of the No. 1 fold seat switch assembly or No. 2 fold seat switch assembly until the reinitialization process complete buzzer sounds.
When the initial position memory reset is completed, a buzzer will sound 3 times.