Home › Audio / Visual / Telematics › AUDIO / VIDEO › ACTIVE NOISE CONTROL SYSTEM (for Type B)
RM38G0E _56 Audio / Visual / Telematics _100606 AUDIO / VIDEO _0467500 ACTIVE NOISE CONTROL SYSTEM(for Type B) C

AUDIO / VIDEO  ACTIVE NOISE CONTROL SYSTEM(for Type B)  U010087  Lost Communication With ECM/PCM "A" Missing Message  U012987  Lost Communication With Brake System Control Module Missing Message  U014087  Lost Communication with Body Control Module Missing Message  U016487  Lost Communication with HVAC Control Module Missing Message  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the CAN communication circuit.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
U010087 Lost Communication With ECM/PCM "A" Missing Message When the stereo component equalizer assembly detects a CAN communication malfunction in the engine system for 1 second or more continuously 3 seconds after the ignition switch is turned to ON* CAN communication system Active Noise Control B
U012987 Lost Communication With Brake System Control Module Missing Message When the stereo component equalizer assembly detects a CAN communication malfunction in the brake system for 1 second or more continuously 3 seconds after the ignition switch is turned to ON* CAN communication system Active Noise Control B
U014087 Lost Communication with Body Control Module Missing Message When the stereo component equalizer assembly detects a CAN communication malfunction in the main body ECU for 3 seconds or more continuously 3 seconds after the ignition switch is turned to ON* CAN communication system Active Noise Control B
U016487 Lost Communication with HVAC Control Module Missing Message When the stereo component equalizer assembly detects a CAN communication malfunction in the air conditioning system for 25 seconds or more continuously 3 seconds after the ignition switch is turned to ON* CAN communication system Active Noise Control B

HINT:

*: Malfunction monitoring is not performed during the following conditions to prevent erroneous detection.

·

The battery voltage is less than 9.5 V.

·

Before 3 seconds have elapsed after the battery voltage has returned to normal.



PROCEDURE

1.CLEAR DTC
Body Electrical > Active Noise Control > Clear DTCs
50002 415
Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
Body Electrical > Active Noise Control > Trouble Codes
50001 415
Result:
Result Proceed to
DTCs are not output A
DTCs are output B


HINT:
·

If CAN communication system malfunction DTCs are output, they may also be output for other systems.

·

If the CAN communication system has been checked and repaired in other systems, the DTC will not be output after rechecking for DTCs.

·

If the DTC is output frequently, duplicate the conditions that cause a malfunction and perform the check again, even though the DTC was not output after rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




A

B