Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM
RM38G0E _56 Audio / Visual / Telematics _100606 AUDIO / VIDEO _0467498 REAR SEAT ENTERTAINMENT SYSTEM J

AUDIO / VIDEO  REAR SEAT ENTERTAINMENT SYSTEM  Display Mode Signal Circuit between Multi-display Controller and Television Display Assembly  


DESCRIPTION

This is the display mode signal circuit between the multi-display controller to the television display assembly RH.

WIRING DIAGRAM

E246907E58
1.781,0.99 2.146,1.229 0.365,0.24 10 false MD0 2.198,0.854 2.396,1.021 0.198,0.167 10 false 9 4.833,0.854 5.031,1.021 0.198,0.167 10 false 1 4.74,1.99 7.01,2.313 2.271,0.323 10 false Television Display Assembly RH 1.104,1.979 2.552,2.417 1.448,0.438 10 false Multi-display Controller 1.115,1.802 1.625,2.021 0.51,0.219 10 false Q29 4.74,1.802 5.25,2.01 0.51,0.208 10 false q1 5.063,0.958 5.542,1.167 0.479,0.208 10 false MDO

PROCEDURE

1.CHECK TELEVISION DISPLAY ASSEMBLY RH
E195974C71
1.438,0.25 2,0.563 0.563,0.313 2.667,0.354 2.51,0.354 2.51,0.354 2.146,1.094 false 1.625,0.323 2.24,0.521 0.615,0.198 10 false q1 0.083,0.073 0.396,0.271 0.313,0.198 10 false *a 2.74,0.271 3.354,0.469 0.615,0.198 10 false MDO
*a Component with harness connected
(Television Display Assembly RH)


a.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition

Click Location & Routing(q1)Location & Routing

Click Connector(q1)Seat>Seat Audio Wire>Television Display Assembly RH

q1-1 (MDO) - Body ground Television display assembly ON Higher than 3.5 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER - TELEVISION DISPLAY ASSEMBLY RH)

NG

REPLACE TELEVISION DISPLAY ASSEMBLY RH

2.CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER - TELEVISION DISPLAY ASSEMBLY RH)
a.

Disconnect the Q29 multi-display controller connector.


b.

Disconnect the q1 television display assembly RH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(Q29,q1)Location & Routing

Click Connector(Q29)Seat>Floor Wire>Multi-Display Controller

Click Connector(q1)Seat>Seat Audio Wire>Television Display Assembly RH

Q29-9 (MD0) - q1-1 (MDO) Always Below 1 Ω
Q29-9 (MD0) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR