Home › Engine / Hybrid System › V35A-FTS (ENGINE MECHANICAL) › DRIVE BELT
RM38G0E _51 Engine / Hybrid System _100652 V35A-FTS ENGINE MECHANICAL _0467569 DRIVE BELT G

V35A-FTS ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16361A 1.INSPECT FAN AND GENERATOR V BELT

HINT:

Check only when reused.


a.
B000543

Check the fan and generator V belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the fan and generator V belt.

·

The fan and generator V belt is cracked.

·

The fan and generator V belt is worn to the extent that the cords are exposed.

·

The fan and generator V belt has chunks missing from the ribs.



b.
B000540

Check that the fan and generator V belt fits properly in the ribbed grooves.

HINT:

Check by hand to confirm that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the fan and generator V belt. Install a new fan and generator V belt correctly.



Hide 88310A 2.INSPECT NO. 1 V BELT (COOLER COMPRESSOR TO CRANKSHAFT PULLEY)

HINT:

Check only when reused.


a.
B000543

Check the No. 1 V belt (cooler compressor to crankshaft pulley) for wear, cracks or other signs of damage.

If any of the following defects is found, replace the No. 1 V belt (cooler compressor to crankshaft pulley).

·

The No. 1 V belt (cooler compressor to crankshaft pulley) is cracked.

·

The No. 1 V belt (cooler compressor to crankshaft pulley) is worn to the extent that the cords are exposed.

·

The No. 1 V belt (cooler compressor to crankshaft pulley) has chunks missing from the ribs.



b.
B000540

Check that the No. 1 V belt (cooler compressor to crankshaft pulley) fits properly in the ribbed grooves.

HINT:

Check by hand to confirm that the No. 1 V belt (cooler compressor to crankshaft pulley) has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the No. 1 V belt (cooler compressor to crankshaft pulley). Install a new No. 1 V belt (cooler compressor to crankshaft pulley) correctly.



Hide 16620D 3.INSPECT V-RIBBED BELT TENSIONER ASSEMBLY

a.

Check that nothing is caught in the V-ribbed belt tensioner assembly by turning it clockwise and counterclockwise.

If a malfunction exists, replace the V-ribbed belt tensioner assembly.


Hide 16601 4.INSPECT V-RIBBED BELT TENSIONER SUB-ASSEMBLY

a.

Check that nothing is caught in the V-ribbed belt tensioner sub-assembly by turning it clockwise and counterclockwise.

If a malfunction exists, replace the V-ribbed belt tensioner sub-assembly.