84975 1.INSPECT TRIP SWITCH (PANORAMIC VIEW MONITOR SWITCH)
| *a | Component without harness connected (Trip Switch (Panoramic View Monitor Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I80)Location & Routingewd_type=routing;type=c;code=I80 |
||
| I80-6 (ECU) - I80-3 (E) | Panoramic view monitor switch pushed | Below 1 Ω |
| I80-6 (ECU) - I80-3 (E) | Panoramic view monitor switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the trip switch (panoramic view monitor switch).
| *a | Component without harness connected (Trip Switch (Panoramic View Monitor Switch)) |
Check the illumination.
Apply battery voltage to the connector and check the illumination conditions.
| Tester Connection | Specified Condition |
|---|---|
Click Location & Routing(I80)Location & Routingewd_type=routing;type=c;code=I80 |
|
| Battery positive (+) - I80-7 (ILL+) Battery negative (-) - I80-2 (ILL-) |
LED Illuminates |
If the result is not as specified, replace the trip switch (panoramic view monitor switch).