81360T 1.INSPECT SPOT LIGHT ASSEMBLY
Check the illumination.
| *a | Component without harness connected (Spot Light Assembly) |
Apply battery voltage to the connector and check the light illumination condition.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
Click Location & Routing(d12)Location & Routingewd_type=routing;type=c;code=d12 Click Connector(d12)Body>No. 1 Roof Wire>Map Light Assembly (Rear)ewd_type=component;type=c;code=d12;pinno=5,1,3 |
||
| d12-5 (B) - Battery positive (+) d12-1 (CTY) - Battery negative (-) |
Spot light switch LH OFF | Spot light LH illuminates |
| Spot light switch RH OFF | Spot light RH illuminates | |
| d12-5 (B) - Battery positive (+) d12-3 (E) - Battery negative (-) |
Spot light switch LH ON | Spot light LH illuminates |
| Spot light switch RH ON | Spot light RH illuminates | |
If the result is not as specified, replace the spot light assembly.
81240D 2.INSPECT NO. 2 ROOM LIGHT ASSEMBLY
Check the illumination.
| *a | Component without harness connected (No. 2 Room Light Assembly) |
Apply battery voltage to the connector and check the light illumination condition.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
Click Location & Routing(d15)Location & Routingewd_type=routing;type=c;code=d15 Click Connector(d15)Body>No. 1 Roof Wire>No. 2 Room Light Assembly (Rear2)ewd_type=component;type=c;code=d15;pinno=5,1,3 |
||
| d15-5 (DB) - Battery positive (+) d15-1 (DL) - Battery negative (-) |
No. 2 room light assembly switch OFF | No. 2 room light assembly illuminates |
| d15-5 (DB) - Battery positive (+) d15-3 (L) - Battery negative (-) |
No. 2 room light assembly switch ON | No. 2 room light assembly illuminates |
If the result is not as specified, replace the No. 2 room light assembly.