84234 1.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (for LH Side)
| *a | Component without harness connected (Rear Door Courtesy Light Switch Assembly) |
Inspect the rear door courtesy light switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
Click Location & Routing(S16)Location & Routingewd_type=routing;type=c;code=S16 Click Connector(S16)Body>No. 2 Floor Wire / Step Rear Floor Wire LH>Rear Door Courtesy Light Switch Assembly LHewd_type=component;type=c;code=S16;pinno=1 |
||
| S16-1 - Switch body | Pushed | 10 kΩ or higher |
| Not pushed | Below 1 Ω | |
Connect the negative (-) tester lead near the bolt hole.
If the result is not as specified, replace the rear door courtesy light switch assembly.
84234 2.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (for RH Side)
| *a | Component without harness connected (Rear Door Courtesy Light Switch Assembly) |
Inspect the rear door courtesy light switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
Click Location & Routing(Q24)Location & Routingewd_type=routing;type=c;code=Q24 |
||
| Q24-1 - Switch body | Pushed | 10 kΩ or higher |
| Not pushed | Below 1 Ω | |
Connect the negative (-) tester lead near the bolt hole.
If the result is not as specified, replace the rear door courtesy light switch assembly.