84975 1.INSPECT TRIP SWITCH
| *1 | ODO TRIP Switch |
| *a | Component without harness connected (Trip Switch) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I80)Location & Routingewd_type=routing;type=c;code=I80 |
||
| I80-5 (+) - I80-4 (E) | ODO/TRIP switch pressed | Below 1 Ω |
| ODO/TRIP switch not pressed | 10 kΩ or higher | |
If the result is not as specified, replace the trip switch.
| *1 | ODO TRIP Switch |
| *a | Component without harness connected (Trip Switch) |
Check illumination.
Apply auxiliary battery voltage to the connector and check the light illumination condition.
| Tester Connection | Specified Condition |
|---|---|
Click Location & Routing(I80)Location & Routingewd_type=routing;type=c;code=I80 |
|
| Battery positive (+) → I80-7 (ILL+) Battery negative (-) → I80-2(ILL-) |
Illuminates |
If the result is not as specified, replace the trip switch.