Home › Vehicle Interior › HEATING / AIR CONDITIONING › REAR EVAPORATOR TEMPERATURE SENSOR
RM38G0E _58 Vehicle Interior _100766 HEATING / AIR CONDITIONING _0467920 REAR EVAPORATOR TEMPERATURE SENSOR G

HEATING / AIR CONDITIONING  REAR EVAPORATOR TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 88605C 1.INSPECT NO. 2 COOLER WIRING HARNESS SUB-ASSEMBLY (REAR EVAPORATOR TEMPERATURE SENSOR)

a.
E465125C01
2,1.969 2.365,2.156 0.365,0.188 0.615,0.74 0.615,0.438 true 1.542,3.542 1.667,3.094 1.667,3.094 1.813,3.094 true 1.594,1.646 1.958,1.344 true 1.896,1.823 2.104,1.344 true 1.427,0.844 1.74,1 0.313,0.156 10 false *a 0.552,0.771 0.865,0.927 0.313,0.156 10 false *b 0.333,2.156 0.646,2.313 0.313,0.156 10 false *c 0.292,4.469 0.604,4.625 0.313,0.156 10 false *d 1.875,2.99 2.188,3.146 0.313,0.156 10 false *e 0.51,4.458 0.823,4.615 0.313,0.156 10 false (14) 1.094,4.469 1.406,4.625 0.313,0.156 10 false (32) 1.719,4.458 2.031,4.615 0.313,0.156 10 false (50) 2.333,4.469 2.646,4.625 0.313,0.156 10 false (68) 2.979,4.469 3.292,4.625 0.313,0.156 10 false (86) 1.49,1.635 1.802,1.792 0.313,0.156 10 false + 1.854,1.802 2.167,1.958 0.313,0.156 10 false - 2.052,1.969 2.417,2.167 0.365,0.198 10 false Q10
*a Component without harness connected
(No. 2 Cooler Wiring Harness Sub-assembly (Rear Evaporator Temperature Sensor))
*b Sensing Portion
*c Resistance (kΩ)
*d Temperature (°C (°F))
*e Allowable Range


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(Q10)Location & Routing

Click Connector(Q10)Body>Air Conditioning Wiring Harness Assembly / Floor Wire / Step Rear Floor Wire RH / Theft Warning Sensor Cord Sub-Assembly>Rear Cooling Unit Assembly (No. 1 Cooler Wiring Harness Sub-Assembly)

Q10-7 (-) - Q10-8 (+) -10°C (14°F) 7.40 to 9.20 kΩ
Q10-7 (-) - Q10-8 (+) -5°C (23°F) 5.65 to 7.00 kΩ
Q10-7 (-) - Q10-8 (+) 0°C (32°F) 4.35 to 5.40 kΩ
Q10-7 (-) - Q10-8 (+) 5°C (41°F) 3.40 to 4.20 kΩ
Q10-7 (-) - Q10-8 (+) 10°C (50°F) 2.68 to 3.30 kΩ
Q10-7 (-) - Q10-8 (+) 15°C (59°F) 2.10 to 2.60 kΩ
Q10-7 (-) - Q10-8 (+) 20°C (68°F) 1.66 to 2.10 kΩ
Q10-7 (-) - Q10-8 (+) 25°C (77°F) 1.32 to 1.66 kΩ
Q10-7 (-) - Q10-8 (+) 30°C (86°F) 1.05 to 1.35 kΩ


NOTICE:
·

Hold the sensor only by its connector. Touching the sensing portion may change the resistance value.

·

When measuring, the sensor temperature must be the same as the ambient temperature.



HINT:

As the temperature increases, the resistance decreases (see the graph).


If the result is not as specified, replace the No. 2 cooler wiring harness sub-assembly (rear evaporator temperature sensor).