REFRIGERANT SHORTAGE CHECK USING GTS
Prepare the vehicle according to the table below.
| Item | Condition |
|---|---|
| Vehicle Condition | Engine running |
| A/C Switch | On |
| Ambient Temperature*1 | 0 to 49°C (32 to 120°F) |
| Air Conditioning Air Inlet Temperature*2 | 25 to 35°C (77 to 95°F) |
| Set Temperature | MAX COLD |
| Recirculation/fresh Control Switch | Recirculation |
| Air Vent Damper Position | FACE |
| Blower Speed | HI |
*1: This inspection can be judged correctly only if the ambient temperature is within a range of 0 to 49°C (32 to 120°F). Therefore, postpone the test if the temperature is low.
*2: This inspection can be judged correctly only if the air inlet temperature is within a range of 25 to 35°C (77 to 95°F). Therefore, postpone the test if the temperature is out of range.
Using the GTS, check the amount of refrigerant.
| Tester Display |
|---|
| Refrigerant Gas Volume Check |
If the conditions for the inspection are not met, "Refrigerant incorrect" will be displayed on the GTS. Confirm the conditions of the inspection and perform the check again.
If the amount of refrigerant is insufficient, "Refrigerant shortage" is displayed on the GTS and the indicator light on the A/C switch turns off.
When performing this inspection, a DTC will not be output even if "Refrigerant shortage" is displayed on the GTS.
| Result | Amount of Refrigerant | Corrective Action |
|---|---|---|
| Refrigerant shortage | Insufficient |
1.
Check for refrigerant leaks using a halogen leak detector, and repair if necessary. |
| Refrigerant correct | Correct | - |
| Refrigerant incorrect | Incorrect | Confirm the conditions of the inspection and perform the check again. |
REFRIGERANT PRESSURE HISTORY CLEAR
Press the A/C OFF switch.
According to the GTS display, perform refrigerant pressure history clear.
| Tester Display |
|---|
| Refrigerant Pressure History Clear |
A/C OPERATION LIMIT HISTORY COUNT CLEAR
Press the A/C OFF switch.
According to the GTS display, perform A/C operation limit history count clear.
| Tester Display |
|---|
| A/C Operation Limit History Count Clear |
ALL READINESS
With "All Readiness", you can check whether or not the DTC judgment has been completed by using the GTS.
You should check "All Readiness" after simulating malfunction symptoms or for validation after finishing repairs.
Clear the DTCs even if no DTCs are stored.
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON.
Perform the DTC judgment driving pattern to run the DTC judgment.
According to the GTS display, perform all readiness.
| Tester Display |
|---|
| All Readiness |
Input the DTCs to be confirmed.
Check the DTC judgment result.
| GTS Display | Description |
|---|---|
|
If the judgment result shows Incomplete, perform the DTC confirmation driving pattern again. |
|
| Normal |
·
DTC judgment completed
·
System normal |
| Abnormal |
·
DTC judgment completed
·
System abnormal |
| Incomplete |
·
DTC judgment not completed
·
Perform the driving pattern |