88625P 1.INSPECT COOLER THERMISTOR (AMBIENT TEMPERATURE SENSOR)
| *a | Component without harness connected (Cooler Thermistor (Ambient Temperature Sensor)) |
| *b | Sensing Portion |
| *c | Resistance (kΩ) |
| *d | Temperature (°C (°F)) |
| *e | Allowable Range |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(A9)Location & Routingewd_type=routing;type=c;code=A9 Click Connector(A9)Engine Compartment>No. 4 Engine Room Wire / Switch Wire>Cooler (Ambient Temperature Sensor) Thermistorewd_type=component;type=c;code=A9;pinno=1,2 |
||
| A9-1 - A9-2 | 10°C (50°F) | 3.00 to 3.73 kΩ |
| A9-1 - A9-2 | 15°C (59°F) | 2.45 to 2.88 kΩ |
| A9-1 - A9-2 | 20°C (68°F) | 1.95 to 2.30 kΩ |
| A9-1 - A9-2 | 25°C (77°F) | 1.60 to 1.80 kΩ |
| A9-1 - A9-2 | 30°C (86°F) | 1.28 to 1.47 kΩ |
| A9-1 - A9-2 | 35°C (95°F) | 1.00 to 1.22 kΩ |
| A9-1 - A9-2 | 40°C (104°F) | 0.80 to 1.00 kΩ |
| A9-1 - A9-2 | 45°C (113°F) | 0.65 to 0.85 kΩ |
| A9-1 - A9-2 | 50°C (122°F) | 0.50 to 0.70 kΩ |
| A9-1 - A9-2 | 55°C (131°F) | 0.44 to 0.60 kΩ |
| A9-1 - A9-2 | 60°C (140°F) | 0.36 to 0.50 kΩ |
Hold the sensor only by its connector. Touching the sensing portion may change the resistance value.
Perform the measurement once the sensor has adapted to the ambient temperature.
Use a thermometer to detect the ambient temperature of the installation area around the cooler thermistor (ambient temperature sensor).
As the temperature increases, the resistance decreases (see the graph).
If the result is not as specified, replace the cooler thermistor (ambient temperature sensor).