84794A 1.INSPECT FRONT WIPER DEICER RELAY (DEICER)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage is applied between terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the front wiper deicer relay.
85912F 2.INSTALL NO. 1 HWD RELAY (HWD NO. 1)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 4 | Battery voltage is not applied between terminals 1 and 2 | Below 1 Ω |
| Battery voltage is applied between terminals 1 and 2 | 10 kΩ or higher | |
| 3 - 5 | Battery voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage is applied between terminals 1 and 2 | Below 1 Ω | |
| 4 - 5 | Always | 10 kΩ or higher |
If the result is not as specified, replace the No. 1 HWD relay.
85912F 3.INSTALL NO. 2 HWD RELAY (HWD NO. 2)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 4 | Battery voltage is not applied between terminals 1 and 2 | Below 1 Ω |
| Battery voltage is applied between terminals 1 and 2 | 10 kΩ or higher | |
| 3 - 5 | Battery voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage is applied between terminals 1 and 2 | Below 1 Ω | |
| 4 - 5 | Always | 10 kΩ or higher |
If the result is not as specified, replace the No. 2 HWD relay.