84330 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
| *a | Component without harness connected (Hazard Warning Signal Switch Assembly) |
Inspect the hazard warning signal switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I87)Location & Routingewd_type=routing;type=c;code=I87 |
||
| I87-6(HAZ) - I87-3(E) | Hazard warning signal switch OFF | 10 kΩ or higher |
| Hazard warning signal switch ON | Below 1 Ω | |
If the result is not as specified, replace the hazard warning signal switch assembly.
| *a | Component without harness connected (Hazard Warning Signal Switch Assembly) |
Check the illumination.
Apply battery voltage to the hazard warning signal switch assembly and check that the lights illuminate.
| Tester Connection | Specified Condition |
|---|---|
Click Location & Routing(I87)Location & Routingewd_type=routing;type=c;code=I87 |
|
| Battery positive (+) - Terminal I87-7(ILL+) Battery negative (-) - I87-2(ILL-) |
Hazard warning signal switch assembly illuminates |
If the result is not as specified, replace the hazard warning signal switch assembly.