89120A 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR
Disconnect the automatic light control sensor connector.
| *a | Front view of wire harness connector (to Automatic Light Control Sensor) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(K4)Location & Routingewd_type=routing;type=c;code=K4 Click Connector(K4)Instrument Panel>No. 3 Instrument Panel Wire>Automatic Light Control Sensorewd_type=component;type=c;code=K4;pinno=1,2 |
||
| K4-1(CLTB) - K4-2(CLTE) | Ignition switch on (IG) | 11 to 14 V |
If the result is not as specified, repair or replace the wire harness.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(K4)Location & Routingewd_type=routing;type=c;code=K4 Click Connector(K4)Instrument Panel>No. 3 Instrument Panel Wire>Automatic Light Control Sensorewd_type=component;type=c;code=K4;pinno=2 |
||
| K4-2 (CLTE) - Body ground | Always | Below 1 Ω |
If the result is not as specified, repair or replace the wire harness.
Reconnect the automatic light control sensor connector.
| *a | Component with harness connected (Automatic Light Control Sensor) |
Connect an oscilloscope to the automatic light control sensor connector.
Check the waveform.
| Tester Connection | Tool Setting | Condition | Specified Condition |
|---|---|---|---|
Click Location & Routing(K4)Location & Routingewd_type=routing;type=c;code=K4 Click Connector(K4)Instrument Panel>No. 3 Instrument Panel Wire>Automatic Light Control Sensorewd_type=component;type=c;code=K4;pinno=4,2 |
|||
| K4-4(CLTS) - K4-2(CLTE) | 2 V/DIV., 10 ms./DIV. | Ignition switch on (IG), light control switch in AUTO position | Correct waveform is as shown |
The communication waveform changes according to the surrounding brightness.
If the result is not as specified, replace the automatic light control sensor.