84153 1.INSPECT AUTO HIGH BEAM SWITCH
Inspect the auto high beam switch.
| *a | Component without harness connected (Auto High Beam Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I81)Location & Routingewd_type=routing;type=c;code=I81 |
||
| I81-5(+B) - I81-2(E) | Auto high beam switch OFF | 10 kΩ or higher |
| I81-5(+B) - I81-2(E) | Auto high beam switch ON | Below 1 Ω |
If the result is not as specified, replace the auto high beam switch.
Check the illumination.
| *a | Component without harness connected (Auto High Beam Switch) |
Apply battery voltage to the auto high beam switch and check that the lights illuminate.
| Tester Connection | Specified Condition |
|---|---|
Click Location & Routing(I81)Location & Routingewd_type=routing;type=c;code=I81 |
|
| Battery positive (+) - Terminal I81-6(ILL+) Battery positive (+) - I81-1(ILL-) |
Auto high beam switch lluminates |
If the result is not as specified, replace the auto high beam switch.
Check the Indicator illumination.
| *a | Component without harness connected (Auto High Beam Switch) |
Apply battery voltage to the auto high beam switch and check that the Indicator lights illuminate.
| Tester Connection | Specified Condition |
|---|---|
Click Location & Routing(I81)Location & Routingewd_type=routing;type=c;code=I81 |
|
| Battery positive (+) - Terminal I81-3(IND+) Battery positive (+) - I81-4(AZBI) |
Auto high beam switch Indicator lluminates |
If the result is not as specified, replace the auto high beam switch.