86160 1.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY (for LH Side)
With the speaker in the installed condition, check there are no abnormalities such looseness or rattling.
Check that there is no foreign matter inside the speaker.
Check that the speaker cone is not damaged.
| *a | Component without harness connected (Front No. 1 Speaker Assembly) |
Measure the resistance according to the value(s) in the table below.
for 14 Speakers:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(M9)Location & Routingewd_type=routing;type=c;code=M9 Click Connector(M9)Body>Front Door Wire RH>Front No. 1 Speaker Assembly RHewd_type=component;type=c;code=M9;pinno=1,2 |
||
| M9-1 (-) - M9-2 (+) | Always | 4.5 to 6.7 Ω |
If the result is not as specified, replace the front No. 1 speaker assembly.
except 14 Speakers:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(M9)Location & Routingewd_type=routing;type=c;code=M9 Click Connector(M9)Body>Front Door Wire RH>Front No. 1 Speaker Assembly RHewd_type=component;type=c;code=M9;pinno=1,2 |
||
| M9-1 (-) - M9-2 (+) | Always | 4 Ω |
If the result is not as specified, replace the front No. 1 speaker assembly.
86160 2.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY (for RH Side)
With the speaker in the installed condition, check there are no abnormalities such looseness or rattling.
Check that there is no foreign matter inside the speaker.
Check that the speaker cone is not damaged.
| *a | Component without harness connected (Front No. 1 Speaker Assembly) |
Measure the resistance according to the value(s) in the table below.
for 14 Speakers:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(N7)Location & Routingewd_type=routing;type=c;code=N7 Click Connector(N7)Body>Front Door Wire LH>Front No. 1 Speaker Assembly LHewd_type=component;type=c;code=N7;pinno=1,2 |
||
| N7-1 (-) - N7-2 (+) | Always | 4.5 to 6.7 Ω |
If the result is not as specified, replace the front No. 1 speaker assembly.
except 14 Speakers:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(N7)Location & Routingewd_type=routing;type=c;code=N7 Click Connector(N7)Body>Front Door Wire LH>Front No. 1 Speaker Assembly LHewd_type=component;type=c;code=N7;pinno=1,2 |
||
| N7-1 (-) - N7-2 (+) | Always | 4 Ω |
If the result is not as specified, replace the front No. 1 speaker assembly.