Home › Audio / Visual / Telematics › AUDIO / VIDEO › LUGGAGE SPEAKER
RM38G0E _56 Audio / Visual / Telematics _100606 AUDIO / VIDEO _0468149 LUGGAGE SPEAKER G

AUDIO / VIDEO  LUGGAGE SPEAKER  INSPECTION  


PROCEDURE

Hide 86150 1.INSPECT NO. 1 SPEAKER WITH BOX ASSEMBLY

a.

With the speaker in the installed condition, check there are no abnormalities such as looseness or rattling.


b.

Check that there is no foreign matter inside the speaker.


c.

Check that the speaker cone is not damaged.


d.

Measure the resistance according to the value(s) in the table below.

i.
E199617C71
1.479,0.354 1.875,0.625 0.396,0.271 0.906,1.26 1.552,1.26 true 1.896,1.26 2.542,1.26 true 1.563,0.406 2.021,0.604 0.458,0.198 10 false T15 0.5,1.177 0.948,1.365 0.448,0.188 10 false WF1+ 2.583,1.167 3.021,1.365 0.438,0.198 10 false WF1- 0.042,0.042 0.417,0.281 0.375,0.24 12 false *a
*a Component without harness connected
(No. 1 Speaker with Box Assembly)


for 10 Speakers:

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(T15)Location & Routing

Click Connector(T15)Body>No. 3 Floor Wire / Theft Warning Sensor Cord Sub-Assembly>No. 1 Speaker with Box Assembly

T15-1 (WF1-) - T15-2 (WF1+) Always 2.5 Ω


If the result is not as specified, replace the No. 1 speaker with box assembly.


ii.
E199616C26
1.521,0.208 1.885,0.458 0.365,0.25 0.833,1.521 1.292,1.313 true 2.146,1.323 2.635,1.5 true 1.854,1.396 2.042,1.854 true 1.573,1.406 1.323,1.854 true 0.042,0.042 0.271,0.26 0.229,0.219 12 false *a 1.573,0.26 1.865,0.427 0.292,0.167 10 false T16 1.156,1.896 1.542,2.094 0.385,0.198 10 false WF2- 0.417,1.458 0.833,1.646 0.417,0.188 10 false WF2+ 2.031,1.906 2.448,2.104 0.417,0.198 10 false WF1+ 2.719,1.458 3.104,1.656 0.385,0.198 10 false WF1-
*a Component without harness connected
(No. 1 Speaker with Box Assembly)


for 14 Speakers:

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(T16)Location & Routing

Click Connector(T16)Body>No. 3 Floor Wire / Theft Warning Sensor Cord Sub-Assembly>No. 1 Speaker with Box Assembly

T16-1 (WF1-) - T16-2 (WF1+)
T16-3 (WF2-) - T16-4 (WF2+)
Always 4.2 to 6.4 Ω


If the result is not as specified, replace the No. 1 speaker with box assembly.