73204A 1.INSPECT FRONT SEAT BELT SET LH (for LHD)
w/o Memory:
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Front Seat Belt Set LH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(S29)Location & Routingewd_type=routing;type=c;code=S29 Click Connector(S29)Seat>No. 2 Floor Wire>Front Seat Belt Set LHewd_type=component;type=c;code=S29;pinno=1,2,3 |
||
| S29-1 - S29-2 | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher | |
| S29-2 - S29-3 | Seat belt unfastened | 10 kΩ or higher |
| Seat belt fastened | Below 1 Ω | |
If the result is not as specified, replace the front seat belt set LH.
w/ Memory:
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Front Seat Belt Set LH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(S29,i15)Location & Routingewd_type=routing;type=c,c;code=S29,i15 Click Connector(S29)Seat>No. 2 Floor Wire>Front Seat Belt Set LHewd_type=component;type=c;code=S29;pinno=2,1 Click Connector(i15)Seat>Front Seat Wire LH>Front Seat Belt Set LHewd_type=component;type=c;code=i15;pinno=1 |
||
| S29-2 - i15-1 | Seat belt unfastened | 10 kΩ or higher |
| Seat belt fastened | Below 1 Ω | |
| S29-1 - S29-2 | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher | |
If the result is not as specified, replace the front seat belt set LH.
73203 2.INSPECT FRONT SEAT BELT SET RH (for LHD)
| *a | Component without harness connected (Front Seat Belt Set RH) |
- | - |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(Q46)Location & Routingewd_type=routing;type=c;code=Q46 Click Connector(Q46)Seat>Floor Wire>Front Seat Belt Set RHewd_type=component;type=c;code=Q46;pinno=1,2,3,5,4 |
||
| Q46-1 - Q46-2 | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher | |
| Q46-2 - Q46-3 | Seat belt unfastened | 10 kΩ or higher |
| Seat belt fastened | Below 1 Ω | |
| Q46-5 - A-3 | Always | Below 1 Ω |
| Q46-4 - A-1 | Always | Below 1 Ω |
If the result is not as specified, replace the front seat belt set RH.
73203 3.INSPECT FRONT SEAT BELT SET RH (for RHD)
w/o Memory:
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Front Seat Belt Set RH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(Q46)Location & Routingewd_type=routing;type=c;code=Q46 Click Connector(Q46)Seat>Floor Wire>Front Seat Belt Set RHewd_type=component;type=c;code=Q46;pinno=1,2,3 |
||
| Q46-1 - Q46-2 | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher | |
| Q46-2 - Q46-3 | Seat belt unfastened | 10 kΩ or higher |
| Seat belt fastened | Below 1 Ω | |
If the result is not as specified, replace the front seat belt set RH.
w/ Memory:
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Front Seat Belt Set RH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(Q46,h20)Location & Routingewd_type=routing;type=c,c;code=Q46,h20 Click Connector(Q46)Seat>Floor Wire>Front Seat Belt Set RHewd_type=component;type=c;code=Q46;pinno=2,1 Click Connector(h20)Seat>Front Seat Wire RH>Front Seat Belt Set RHewd_type=component;type=c;code=h20;pinno=1 |
||
| Q46-2 - h20-1 | Seat belt unfastened | 10 kΩ or higher |
| Seat belt fastened | Below 1 Ω | |
| Q46-1 - Q46-2 | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher | |
If the result is not as specified, replace the front seat belt set RH.
73204A 4.INSPECT FRONT SEAT BELT SET LH (for RHD)
| *a | Component without harness connected (Front Seat Belt Set LH) |
- | - |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(S29)Location & Routingewd_type=routing;type=c;code=S29 Click Connector(S29)Seat>No. 2 Floor Wire>Front Seat Belt Set LHewd_type=component;type=c;code=S29;pinno=1,2,3,5,4 |
||
| S29-1 - S29-2 | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher | |
| S29-2 - S29-3 | Seat belt unfastened | 10 kΩ or higher |
| Seat belt fastened | Below 1 Ω | |
| S29-5 - A-3 | Always | Below 1 Ω |
| S29-4 - A-1 | Always | Below 1 Ω |
If the result is not as specified, replace the front seat belt set LH.