Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Seat Type RH Side)
RM38G0E _58 Vehicle Interior _100612 SEAT BELT _0468157 REAR NO. 1 SEAT INNER BELT ASSEMBLY(for 60/40 Split Seat Type RH Side) G

SEAT BELT  REAR NO. 1 SEAT INNER BELT ASSEMBLY(for 60/40 Split Seat Type RH Side)  INSPECTION  


PROCEDURE

Hide 73380C 1.INSPECT REAR NO. 1 SEAT INNER BELT ASSEMBLY RH

a.
B612176C03
1.479,0.49 1.906,0.729 0.427,0.24 0.104,0.083 0.417,0.24 0.313,0.156 10 false *a 1.604,0.51 1.979,0.719 0.375,0.208 10 false j7
*a Component without harness connected
(Rear No. 1 Seat Inner Belt Assembly RH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(j7)Location & Routing

Click Connector(j7)Seat>Rear Seat Wire RH>Rear No. 1 Seat Belt Assembly Inner RH

j7-1 - j7-2 Seat belt fastened 10 kΩ or higher
j7-1 - j7-2 Seat belt unfastened Below 1 Ω


If the result is not as specified, replace the rear No. 1 seat inner belt assembly RH.


Hide 73350 2.INSPECT REAR CENTER SEAT LAP TYPE BELT ASSEMBLY

a.
B612176C04
1.479,0.49 1.906,0.729 0.427,0.24 0.104,0.083 0.417,0.24 0.313,0.156 10 false *a 1.604,0.51 1.979,0.719 0.375,0.208 10 false j3
*a Component without harness connected
(Rear Center Seat Lap Type Belt Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(j3)Location & Routing

Click Connector(j3)Seat>Rear Seat Wire RH>Rear Seat 3 Point Type Belt Assembly Center

j3-1 - j3-2 Seat belt fastened 10 kΩ or higher
j3-1 - j3-2 Seat belt unfastened Below 1 Ω


If the result is not as specified, replace the rear center seat lap type belt assembly.