| *a | Centering Bolt |
| *b | Standard Bolt |
Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts when making adjustments.
The specified torque for standard bolts is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
1.INSPECT REAR DOOR
Check that the clearance measurements of areas "A" to "O" are within the standard ranges.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 3.2 to 7.2 mm (0.1260 to 0.2835 in.) | B | -2.0 to 2.0 mm (-0.0787 to 0.0787 in.) |
| C | 2.95 to 6.05 mm (0.1161 to 0.2382 in.) | D | 1.15 to 4.85 mm (0.0453 to 0.1909 in.) |
| E | 4.2 to 8.2 mm (0.1654 to 0.3228 in.) | F | 3.3 to 5.9 mm (0.1299 to 0.2323 in.) |
| G | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) | H | 4.3 to 7.7 mm (0.1693 to 0.3031 in.) |
| I | 4.3 to 7.7 mm (0.1693 to 0.3031 in.) | J | 3.6 to 6.0 mm (0.1417 to 0.2362 in.) |
| K | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) | L | 3.6 to 6.0 mm (0.1417 to 0.2362 in.) |
| M | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) | - | - |
2.ADJUST REAR DOOR
Make sure to turn the ignition switch off when adjusting door lock strikers.
Using SST, loosen the 4 hinge bolts on the vehicle body and adjust the door position.
Using SST, tighten the bolt hinge bolts after the adjustment.
Using SST, loosen the 4 hinge bolts on the door and adjust the door position.
Tighten the 4 hinge bolts on the door after adjustment.
Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.
Using a brass bar and a hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustments.