Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR MAIN SWITCH
RM38G0E _59 Vehicle Exterior _100887 DOOR / HATCH _0468197 POWER BACK DOOR MAIN SWITCH G

DOOR / HATCH  POWER BACK DOOR MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84966 1.INSPECT POWER BACK DOOR CONTROL SWITCH

a.
B577973C07
1.521,1.729 2.021,1.979 0.5,0.25 0.802,3.167 1.25,2.729 true 1.25,3.208 1.469,2.75 true 2.271,3.198 2.031,2.76 true 2.615,3.167 2.24,2.708 true 1.042,3.219 1.5,3.417 0.458,0.198 10 false CLS 2.281,3.198 2.74,3.396 0.458,0.198 10 false E 0.552,3.146 1.01,3.344 0.458,0.198 10 false ILL+ 2.656,3.135 3.115,3.333 0.458,0.198 10 false ILL- 1.677,1.76 2.135,1.958 0.458,0.198 10 false I84 0.438,1.74 0.75,1.896 0.313,0.156 10 false *a
*a Component without harness connected
(Power Back Door Control Switch)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(I84)Location & Routing

Click Connector(I84)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Power Back Door Control Switch

I84-5 (CLS) - I84-2 (E) Pressed (ON) Below 1 Ω
I84-5 (CLS) - I84-2 (E) Not pressed (OFF) 10 kΩ or higher


If the result is not as specified, replace the power back door control switch.



b.

Check that the switch illuminates.

i.

Apply auxiliary battery voltage to the switch connector and check that the power back door control switch illuminates.

OK:
Tester Connection Auxiliary Battery Connection Specified Condition

Click Location & Routing(I84)Location & Routing

Click Connector(I84)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Power Back Door Control Switch

I84-6 (ILL+) - I84-1 (ILL-) Auxiliary battery positive (+) → Terminal 6 (ILL+)
Auxiliary battery negative (-) → Terminal 1 (ILL-)
Illumination illuminates


If the result is not as specified, replace the power back door control switch.