Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR CONTROL SWITCH
RM38G0E _59 Vehicle Exterior _100887 DOOR / HATCH _0468198 POWER BACK DOOR CONTROL SWITCH G

DOOR / HATCH  POWER BACK DOOR CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 84966A 1.INSPECT NO. 1 POWER BACK DOOR CONTROL SWITCH

a.
B577975C08
1.49,1.646 1.99,1.885 0.5,0.24 0.74,3.052 1.125,2.635 true 1.219,3.125 1.406,2.688 true 2.229,3.135 2.031,2.688 true 2.688,3.052 2.292,2.635 true 0.438,1.906 0.875,2.229 0.438,0.323 10 false *a 1.01,3.146 1.469,3.344 0.458,0.198 10 false CLS 2.25,3.156 2.708,3.354 0.458,0.198 10 false E 0.521,3.063 0.979,3.26 0.458,0.198 10 false ILL+ 2.688,3.052 3.146,3.25 0.458,0.198 10 false ILL- 1.625,1.667 2.063,1.99 0.438,0.323 10 false g15
*a Component without harness connected
(No .1 Power Back Door Control Switch)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(g15)Location & Routing

Click Connector(g15)Body>No. 1 Rear Window Wire / No. 2 Back Door Wire>No. 1 Power Back Door Control Switch

g15-5 (CLS) - g15-2 (E) Pressed (ON) Below 1 Ω
g15-5 (CLS) - g15-2 (E) Not pressed (OFF) 10 kΩ or higher


If the result is not as specified, replace the No. 1 power back door control switch.



b.

Check that the switch illuminates.

i.

Apply auxiliary battery voltage to the switch connector and check that the No. 1 power back door control switch illuminates.

OK:
Tester Connection Auxiliary Battery Condition Specified Condition

Click Location & Routing(g15)Location & Routing

Click Connector(g15)Body>No. 1 Rear Window Wire / No. 2 Back Door Wire>No. 1 Power Back Door Control Switch

g15-6 (ILL+) - g15-1 (ILL-) Auxiliary battery positive (+) → Terminal 6 (ILL+)
Auxiliary battery negative (-) → Terminal 1 (ILL-)
Illumination illuminates


If the result is not as specified, replace the No. 1 power back door control switch.