Home › Vehicle Exterior › DOOR / HATCH › RESERVE LOCK SWITCH
RM38G0E _59 Vehicle Exterior _100887 DOOR / HATCH _0468199 RESERVE LOCK SWITCH G

DOOR / HATCH  RESERVE LOCK SWITCH  INSPECTION  


PROCEDURE

Hide 84930 1.INSPECT DOOR CONTROL SWITCH ASSEMBLY

a.
B577977C06
1.469,1.625 1.969,1.875 0.5,0.25 0.844,3.146 1.198,2.708 true 1.188,3.177 1.406,2.698 true 2.188,3.156 2.021,2.698 true 2.625,3.125 2.24,2.688 true 0.552,1.688 0.865,1.844 0.313,0.156 10 false *a 0.969,3.177 1.583,3.375 0.615,0.198 10 false CLLS 0.625,3.135 1.24,3.333 0.615,0.198 10 false ILL+ 2.615,3.135 3.229,3.333 0.615,0.198 10 false ILL- 2.198,3.167 2.396,3.344 0.198,0.177 10 false E 1.594,1.656 1.938,2 0.344,0.344 10 false g16
*a Component without harness connected
(Door Control Switch Assembly)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(g16)Location & Routing

Click Connector(g16)Body>No. 1 Rear Window Wire / No. 2 Back Door Wire>Door Control Switch

g16-5 (CLLS) - g16-2 (E) Pressed (On) Below 1 Ω
g16-5 (CLLS) - g16-2 (E) Not pressed (Off) 10 kΩ or higher


If the result is not as specified, replace the door control switch assembly.



b.

Check the switch illumination.

i.

Apply auxiliary battery voltage to the switch connector and check that the door control switch assembly illuminates.

OK:
Tester Connection Auxiliary Battery Connection Specified Condition

Click Location & Routing(g16)Location & Routing

Click Connector(g16)Body>No. 1 Rear Window Wire / No. 2 Back Door Wire>Door Control Switch

g16-6 (ILL+) - g16-1 (ILL-) Auxiliary battery positive (+) → Terminal 6 (ILL+)
Auxiliary battery negative (-) → Terminal 1 (ILL-)
Illumination illuminates


If the result is not as specified, replace the door control switch assembly.