Use the same procedure for the RH and LH sides.
The procedure below is for the LH side.
68960C 1.DISPOSE OF BACK DOOR STAY SET
Fully extend the back door stay assembly.
Secure the back door stay assembly horizontally in a vise with the piston rod pulled out.
Wearing protective glass, gradually cut the shaded part between "A" and "B" shown the illustration using a metal saw to gradually release the gas.
| Area | Specified Condition |
|---|---|
| a | 283 mm (11.14 in.) |
| b | 22 mm (0.866 in.) |
Always use proper safety equipment and be careful when drilling because shards of metal way fly about.
The gas is colorless, odorless and non-poisonous.