Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM
RM38G0E _59 Vehicle Exterior _100887 DOOR / HATCH _0468264 POWER BACK DOOR SYSTEM C

DOOR / HATCH  POWER BACK DOOR SYSTEM  B220496  Kick Sensor Component Internal Failure  


DESCRIPTION

The multiplex network door ECU communicates with the kick door control sensor assembly via LIN communication. If a malfunction signal is received from the kick door control sensor assembly 3 times consecutively, this DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B220496 Kick Sensor Component Internal Failure Malfunction signal received from kick door control sensor assembly 3 times consecutively
·

Kick door control sensor assembly

·

Multiplex network door ECU

·

Harness or connector


Back Door A

WIRING DIAGRAM

E464754E02
4.063,2.604 6.344,2.885 2.281,0.281 10 false Kick Door Control Sensor Assembly 4.063,2.427 4.604,2.656 0.542,0.229 10 false e5 4.688,1.396 5.219,1.583 0.531,0.188 10 false LIN 2.104,1.406 2.635,1.594 0.531,0.188 10 false MPX1 4.458,1.229 4.99,1.417 0.531,0.188 10 false 1 2.604,1.229 3.135,1.417 0.531,0.188 10 false 18 1.042,2.615 3.177,2.917 2.135,0.302 10 false Multiplex Network Door ECU 1.052,2.427 1.365,2.656 0.313,0.229 10 false T1 0.583,3.427 4.25,3.625 3.667,0.198 10 false : LIN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

Before troubleshooting, make sure that the kick door control sensor is not damaged.

·

Before troubleshooting, be sure to read Precautions for Hands Free Power Back Door.

Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>PRECAUTION

·

If the multiplex network door ECU has been removed and installed or replaced, or if any of the connectors has been disconnected, initialize the power back door system.

Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>INITIALIZATION



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Back Door > Clear DTCs
50002 489

Result:
Proceed to
NEXT



NEXT

2.REPRODUCE DTC
2.REPRODUCE DTC
a.

Turn the ignition switch to ON and wait for at least 10 seconds.

Body Electrical > Back Door > Trouble Codes
50001 489

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Wait for approximately 60 seconds.


b.

Check for DTCs.

Body Electrical > Back Door > Trouble Codes
50001 489

Result:
Result Proceed to
B220496 is output A
B220496 is not output B



A

REPLACE KICK DOOR CONTROL SENSOR ASSEMBLY

B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE