87510Y 1.INSPECT REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY LH
| *a | Component without harness connected (Rear No. 1 Seat Cushion Heater Assembly LH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(k2)Location & Routingewd_type=routing;type=c;code=k2 Click Connector(k2)Seat>Rear Seat Wire LH>Rear Seat Cushion Heater LH (Rear No. 1 Seat Cushion Pad LH)ewd_type=component;type=c;code=k2;pinno=1,4,5,6,7 |
||
| k2-1 - k2-4 | Always 20°C (68°F) | 2.87 to 3.43 Ω |
| k2-4 - k2-5 | Always 20°C (68°F) | 2.93 to 3.5 Ω |
| k2-6 - k2-7 | Always 20°C (68°F) | 11.94 to 12.24 kΩ |
If the result is not as specified, replace the rear No. 1 seat cushion heater assembly LH.