84040 1.INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
Check the illumination.
| *a | Component without harness connected (Multiplex Network Master Switch Assembly) |
for LHD:
Apply battery voltage to the connector and check the illumination conditions.
| Tester Connection | Specified Condition |
|---|---|
Click Location & Routing(N3)Location & Routingewd_type=routing;type=c;code=N3 Click Connector(N3)Body>Front Door Wire LH>Multiplex Network Master Switch Assemblyewd_type=component;type=c;code=N3;pinno=3,13 |
|
| N3-3 (ILL+) - battery positive (+) N3-13 (ILL-) - battery negative (-) |
Illuminates |
If the result is not as specified, replace the multiplex network master switch assembly.
Check the illumination.
| *a | Component without harness connected (Multiplex Network Master Switch Assembly) |
for RHD:
Apply battery voltage to the connector and check the illumination conditions.
| Tester Connection | Specified Condition |
|---|---|
Click Location & Routing(M4)Location & Routingewd_type=routing;type=c;code=M4 Click Connector(M4)Body>Front Door Wire RH>Multiplex Network Master Switch Assemblyewd_type=component;type=c;code=M4;pinno=3,13 |
|
| M4-3 (ILL+) - battery positive (+) M4-13 (ILL-) - battery negative (-) |
Illuminates |
If the result is not as specified, replace the multiplex network master switch assembly.