Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SWITCH ASSEMBLY
RM38G0E _59 Vehicle Exterior _100826 SLIDING ROOF / CONVERTIBLE _0468596 SLIDING ROOF SWITCH ASSEMBLY G

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF SWITCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT MAP LIGHT SUB-ASSEMBLY (SLIDING ROOF SWITCH)

a.

Measure the resistance according to the value(s) in the table below.

E464969C01
5.281,0.177 5.688,0.365 0.406,0.188 1.635,0.229 2.042,0.417 0.406,0.188 6.25,0.99 6.25,1.26 6.25,1.26 6.656,1.26 true 6.083,0.698 6.083,0.094 6.083,0.094 6.594,0.094 true 6.302,0.771 6.708,0.771 true 6.094,0.99 6.094,1.406 true 0.823,1 0.823,1.375 true 0.823,0.719 0.823,0.438 0.823,0.438 0.656,0.438 true 6.635,0.031 7.094,0.229 0.458,0.198 10 false UP 6.74,0.688 7.115,0.854 0.375,0.167 10 false OPN 0.063,0.052 0.375,0.25 0.313,0.198 10 false *a 5.427,0.198 5.885,0.396 0.458,0.198 10 false d2 6.698,1.188 7,1.365 0.302,0.177 10 false CLS 0.688,1.396 1.104,1.573 0.417,0.177 10 false GND5 5.875,1.438 6.333,1.635 0.458,0.198 10 false DOWN 1.76,0.24 2.219,0.438 0.458,0.198 10 false d1 0.271,0.365 0.698,0.542 0.427,0.177 10 false GND9
*a Component without harness connected(Map Light Sub-assembly (Sliding Roof Switch)) - -


Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(d2,d1)Location & Routing

Click Connector(d2)Body>No. 1 Roof Wire>Map Light Assembly (Front)

Click Connector(d1)Body>No. 1 Roof Wire>Map Light Assembly (Front)

d2-1 (OPN) - d1-10 (GND9) or d1-24 (GND5) OPEN switch is pressed Below 100 Ω
OPEN switch is not pressed 10 kΩ or higher
d2-6 (CLS) - d1-10 (GND9) or d1-24 (GND5) CLOSE switch is pressed Below 100 Ω
CLOSE switch is not pressed 10 kΩ or higher
d2-2 (UP) - d1-10 (GND9) or d1-24 (GND5) UP switch is pressed Below 100 Ω
UP switch is not pressed 10 kΩ or higher
d2-7 (DOWN) - d1-10 (GND9) or d1-24 (GND5) DOWN switch is pressed Below 100 Ω
DOWN switch is not pressed 10 kΩ or higher


If the result is not as specified, replace the map light sub-assembly (sliding roof switch).