Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR (w/o Electronic-Kinetic Dynamic Suspension System)
RM38G0E _53 Suspension _100922 REAR SUSPENSION _0468695 REAR STABILIZER BAR(w/o Electronic-Kinetic Dynamic Suspension System) G

REAR SUSPENSION  REAR STABILIZER BAR(w/o Electronic-Kinetic Dynamic Suspension System)  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The following procedure is for the LH side.



PROCEDURE

Hide 48840A 1.INSPECT REAR STABILIZER LINK ASSEMBLY LH

a.
C371638

Inspect the turning torque of the ball joint.

i.

Secure the rear stabilizer link assembly in a vise using aluminum plates.

NOTICE:

Do not over tighten the vise.



ii.

Install the nut to the rear stabilizer link assembly LH stud.


iii.

Move the stud back and forth several times. Using a torque wrench, turn the stud continuously at a rate of 2 to 3 seconds per turn and take the torque reading on the 5th turn.

Turning torque:

0.05 to 1.96 N*m (1 to 19 kgf*cm, 1 to 17 in.*lbf)


If the turning torque is not within the specified range, replace the rear stabilizer link assembly LH with a new one.



b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.

If the dust cover is cracked or there is grease on it, replace the rear stabilizer link assembly LH with a new one.