Home › Drivetrain › AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE) › TRANSMISSION WIRE
RM38G0E _52 Drivetrain _100436 AC60F AUTOMATIC TRANSMISSION / TRANSAXLE _0468717 TRANSMISSION WIRE G

AC60F AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  INSPECTION  


PROCEDURE

Hide 82125J 1.INSPECT TRANSMISSION WIRE

C319326C63
0.5,0.125 0.917,0.375 0.417,0.25 1.875,0.885 2.01,0.323 false 2.354,1.823 2.167,0.969 false 1.677,0.854 1.479,0.281 false 1.698,1.854 1.969,1 false 0.063,0.052 0.375,0.25 0.313,0.198 10 false *a 1.104,0.167 1.531,0.365 0.427,0.198 10 false OT2- 2.052,0.167 2.458,0.385 0.406,0.219 10 false OT2+ 1.573,1.885 1.885,2.083 0.313,0.198 10 false OT- 2.271,1.875 2.677,2.094 0.406,0.219 10 false OT+ 0.583,0.167 1,0.333 0.417,0.167 10 false C89
*a Component without harness connected (Transmission Wire)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(C89)Location & Routing

Click Connector(C89)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>Automatic Transmission Assembly (Transmission Wire)

C89-3 (OT+) - C89-4 (OT-) Always 79 Ω to 156 kΩ
C89-5 (OT2+) - C89-6 (OT2-) Always 25 Ω to 156 kΩ
C89-3 (OT+) - Body ground Always 10 kΩ or higher
C89-5 (OT2+) - Body ground Always 10 kΩ or higher
C89-4 (OT-) - Body ground Always 10 kΩ or higher
C89-6 (OT2-) - Body ground Always 10 kΩ or higher


HINT:

If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.


Standard Resistance:
ATF Temperature Specified Condition
10°C (50°F) 5 to 8 kΩ
25°C (77°F) 2.5 to 4.5 kΩ
110°C (230°F) 0.22 to 0.28 kΩ


If the result is not as specified, replace the transmission wire.