1.INSPECT SHIFT LOCK CONTROL ECU
If the results of the following inspections are as specified but a malfunction has occurred, replace the shift lock control unit assembly.
Inspect wire harness:
Disconnect the shift lock control ECU connector.
| *a | Front view of wire harness connector (to Shift Lock Control ECU) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I35)Location & Routingewd_type=routing;type=c;code=I35 |
||
| I35-5 (STP) - Body ground | Brake pedal depressed | 11 to 14 V |
| Brake pedal released | Below 1 V | |
| I35-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |
If the result is not as specified, repair or replace the shift lock control ECU wire harness.
| *a | Front view of wire harness connector (to Shift Lock Control ECU) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I35)Location & Routingewd_type=routing;type=c;code=I35 |
||
| I35-2 (E) - Body ground | Always | Below 1 Ω |
If the result is not as specified, repair or replace the shift lock control ECU wire harness.
2.INSPECT TRANSMISSION CONTROL SWITCH
Disconnect the transmission control switch connector.
| *a | Component without harness connected (Transmission Control Switch (Shift Lock Control Unit Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I73)Location & Routingewd_type=routing;type=c;code=I73 |
||
| I73-4 (IG) - I73-5 (S) | Shift lever in S, "+" or "-" | Below 1 Ω |
| Shift lever not in S, "+" or "-" | 10 kΩ or higher | |
| I73-3 (SFTU) - I73-2 (E) | Shift lever held in "+" (Up-shift) |
Below 1 Ω |
| Shift lever not held in "+" (Up-shift) |
10 kΩ or higher | |
| I73-1 (SFTD) - I73-2 (E) | Shift lever held in "-" (Down-shift) |
Below 1 Ω |
| Shift lever not held in "-" (Down-shift) |
10 kΩ or higher | |
If the result is not as specified, replace the shift lock control unit assembly.