Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM38G0E _54 Brake _100997 BRAKE (FRONT) _0468747 FRONT BRAKE G

BRAKE (FRONT)  FRONT BRAKE  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the disc brake cylinder assembly bore and front disc brake piston for rust and scoring.

If necessary, replace the disc brake cylinder assembly and front disc brake piston.


Hide 2.INSPECT PAD LINING THICKNESS

a.

Using a ruler, measure the front disc brake pad lining thickness.

Standard Thickness:

12.5 mm (0.492 in.)


Minimum Thickness:

1.0 mm (0.0394 in.)


If the front disc brake pad lining thickness is less than the minimum thickness, replace the front disc brake pads.

HINT:

Be sure to check the front disc thickness when replacing the front disc brake pads with new ones.



Hide 47748 3.INSPECT FRONT DISC BRAKE ANTI-RATTLE SPRING

a.

Clean the front disc brake anti-rattle spring and check it for deformation and cracks.

If necessary, replace the front disc brake anti-rattle spring.


Hide 4.INSPECT DISC THICKNESS

a.
C455960C01
2.604,1.281 2.438,1.281 2.438,1.281 2.354,1.365 true 2.667,1.229 2.948,1.438 0.281,0.208 10 true *a
*a Micrometer


Using a micrometer, measure the front disc thickness.

Standard Thickness:

32.0 mm (1.260 in.)


Minimum Thickness:

29.0 mm (1.142 in.)


If the front disc thickness is less than the minimum thickness, replace the front disc.


Hide 5.INSPECT DISC RUNOUT

a.

Inspect the front axle hub bearing looseness and front axle hub runout.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>ON-VEHICLE INSPECTION


b.

Hold the front disc, tighten the front disc with the 6 hub nuts.

Torque:
131 N*m (1336 kgf*cm, 97 ft.*lbf)


c.
C457482C01
1.292,1.563 1.292,1.896 1.292,1.896 1.542,1.896 true 1.594,1.833 1.927,2.083 0.333,0.25 10 false *a
*a Dial Indicator with Magnetic Base


Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the front disc.

Maximum Disc Runout:

0.05 mm (0.00196 in.)


NOTICE:

Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor.


If the runout exceeds the maximum value, change the installation position of the front disc to minimize the runout. If the runout exceeds the maximum even when the installation position is changed, replace the front disc.


d.

Remove the 6 hub nuts. and front disc.