These DTCs are stored when a malfunction occurs in the CAN communication circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U010087 | Lost Communication With ECM/PCM "A" Missing Message | When the stereo component equalizer assembly detects a CAN communication malfunction in the engine system for 1 second or more continuously 3 seconds after the ignition switch is turned to ON* | CAN communication system | Active Noise Control | B |
| U012987 | Lost Communication With Brake System Control Module Missing Message | When the stereo component equalizer assembly detects a CAN communication malfunction in the brake system for 1 second or more continuously 3 seconds after the ignition switch is turned to ON* | CAN communication system | Active Noise Control | B |
| U014087 | Lost Communication with Body Control Module Missing Message | When the stereo component equalizer assembly detects a CAN communication malfunction in the main body ECU for 3 seconds or more continuously 3 seconds after the ignition switch is turned to ON* | CAN communication system | Active Noise Control | B |
| U016487 | Lost Communication with HVAC Control Module Missing Message | When the stereo component equalizer assembly detects a CAN communication malfunction in the air conditioning system for 25 seconds or more continuously 3 seconds after the ignition switch is turned to ON* | CAN communication system | Active Noise Control | B |
*: Malfunction monitoring is not performed during the following conditions to prevent erroneous detection.
The battery voltage is less than 9.5 V.
Before 3 seconds have elapsed after the battery voltage has returned to normal.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
If CAN communication system malfunction DTCs are output, they may also be output for other systems.
If the CAN communication system has been checked and repaired in other systems, the DTC will not be output after rechecking for DTCs.
If the DTC is output frequently, duplicate the conditions that cause a malfunction and perform the check again, even though the DTC was not output after rechecking for DTCs.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING