These DTCs are stored when a malfunction occurs in the CAN communication circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U0073 | Sending Malfunction (Navigation to APGS) | CAN bus connection error | CAN communication system | Navigation System | B |
| U0100 | Engine ECU Communication | CAN reception error | CAN communication system | Navigation System | B |
| U0129 | VSC(ECB)ECU Communication | CAN reception error | CAN communication system | Navigation System | B |
| U0140 | Lost Communication with Body Control Module | CAN reception error | CAN communication system | Navigation System | B |
| U0155 | Meter ECU Communication | CAN reception error | CAN communication system | Navigation System | B |
| U0164 | Air Conditioner ECU Communication | CAN reception error | CAN communication system | Navigation System | B |
| U0265 | Lost Communication with Parking Assist Monitor Module | CAN reception error | CAN communication system | Navigation System | B |
| U1110 | Clearance Sonar ECU Communication | CAN reception error | CAN communication system | Navigation System | B |
Pre-procedure1
Clear the DTCs.
Procedure1
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING