Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type, except 12.3 Inch Display)
RM38G0E _56 Audio / Visual / Telematics _100606 AUDIO / VIDEO _0467497 AUDIO AND VISUAL SYSTEM(for Radio and Display Type, except 12.3 Inch Display) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type, except 12.3 Inch Display)  Illumination Circuit  


DESCRIPTION

Power is supplied to the radio and display receiver assembly illumination when the light control switch is in the head position.

WIRING DIAGRAM

E448075E04
4.979,2.771 6.281,3.229 1.302,0.458 10 false Radio and Display Receiver Assembly 5.219,1.25 6.521,1.708 1.302,0.458 10 false ILL+ 5.219,2.198 6.521,2.656 1.302,0.458 10 false GND1 1.365,1.219 2.667,1.677 1.302,0.458 10 false from PANEL Relay 4.729,0.188 6.031,0.646 1.302,0.458 10 false to Other Systems 4.865,1.24 6.167,1.698 1.302,0.458 10 false I13 4.865,1.031 6.167,1.49 1.302,0.458 10 false 15 4.854,2.188 6.156,2.646 1.302,0.458 10 false I11 4.917,1.99 6.219,2.448 1.302,0.458 10 false 1

PROCEDURE

1.CHECK ILLUMINATION
a.

Check if the illumination for the radio and display receiver assembly, heater control switch or others (hazard switch, transmission control switch, etc.) comes on when the light control switch is turned to the head position.

Result:
Result Proceed to
Illumination comes on for all components except radio and display receiver assembly. A
No illumination comes on (radio and display receiver assembly, hazard switch, heater control switch, etc.). B




A

2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)

B

2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
a.

Disconnect the I11 and I13 radio and display receiver assembly connectors.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(I11)Location & Routing

Click Connector(I11)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Radio & Display Receiver Assembly

I11-1 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(I13)Location & Routing

Click Connector(I13)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Radio & Display Receiver Assembly

I13-15 (ILL+) - Body ground Light control switch in head position 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR