The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.
Disconnect the I173 radio and display receiver assembly connector.
Disconnect the I162 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I173,I162)Location & Routingewd_type=routing;type=c,c;code=I173,I162 |
||
| I173-2 (US1-) - I162-9 (UDO-) | Always | Below 1 Ω |
| I173-3 (US1+) - I162-10 (UDO+) | Always | Below 1 Ω |
| I173-5 (USG1) - I162-[12] (UJSS) | Always | Below 1 Ω |
| I173-2 (US1-) - Body ground | Always | 10 kΩ or higher |
| I173-3 (US1+) - Body ground | Always | 10 kΩ or higher |
| I173-5 (USG1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG