This DTC is stored when the telephone transceiver assembly detects one of the following:
The mobilephone battery voltage drops or the mobilephone battery malfunctions.
The mobilephone battery temperature is (temporarily) high.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B15CC49 | Backup Battery Internal Electronic Failure | Mobilephone battery malfunction |
·
Mobilephone battery
·
Telephone transceiver assembly |
Telematics | A |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>PRECAUTION
When replacing the telephone transceiver assembly, make sure to replace it with a new one.
Pre-procedure1
Turn the ignition switch to ON and wait for 10 seconds or more.
Clear the DTCs.
Procedure1
Check for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTC are not output. | A |
| DTCs are output. | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Replace the mobilephone battery with a normal one and check if the same problem occurs again.
Click hereAudio / Visual / Telematics>TELEMATICS>MAYDAY BATTERY>REMOVAL
After replacing the mobilephone battery, perform initialization.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>INITIALIZATION
Clear the DTCs.
Procedure1
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTC are not output. | A |
| DTCs are output. | B |
Post-procedure1
None
A
B
Replace the telephone transceiver assembly with a new one.
| Proceed to |
|---|
| NEXT |
NEXT