The radio receiver assembly and integration control sub-assembly are connected via video signal (digital) lines.
This DTC is stored when a video signal (digital) line is disconnected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1522 | Lost Communication with DCU Video Line Signal | GVIF disconnected (from radio receiver assembly to integration control sub-assembly) |
·
Harness or connector (GVIF cable)
·
Integration control sub-assembly
·
Radio receiver assembly |
D-SEAT SW | A |
When replacing the integration control sub-assembly, always replace it with a new one. If an integration control sub-assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The integration control sub-assembly may not operate normally.
Pre-procedure1
Clear the DTCs.
Procedure1
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Disconnect the I159 radio receiver assembly connector.
Disconnect the I160 integration control sub-assembly connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I159,I160)Location & Routingewd_type=routing;type=c,c;code=I159,I160 |
||
| I159-2 (GV-) - I160-1 (GV2-) | Always | Below 1 Ω |
| I159-1 (GV+) - I160-2 (GV2+) | Always | Below 1 Ω |
| I159-3 (GVG) - I160-3 (GVG2) | Always | Below 1 Ω |
| I159-2 (GV-) or I160-1 (GV2-) - Body ground | Always | 10 kΩ or higher |
| I159-1 (GV+) or I160-2 (GV2+) - Body ground | Always | 10 kΩ or higher |
| I159-3 (GVG) or I160-3 (GVG2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Pre-procedure1
Replace the integration control sub-assembly with a new one.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>MULTI-DISPLAY ECU>REMOVAL
Clear the DTCs.
Procedure1
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio Receiver Type)>REMOVAL