Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM38G0E _56 Audio / Visual / Telematics _100607 NAVIGATION / MULTI INFO DISPLAY _0467503 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Illumination Circuit  


DESCRIPTION

Power is supplied to the radio receiver assembly and steering pad switch assembly when the light control switch is in the tail or head position.

WIRING DIAGRAM

E448075E07
4.771,2.76 6.49,3.198 1.719,0.438 10 false Radio Receiver Assembly 5.219,1.208 5.552,1.406 0.333,0.198 10 false ILL+ 5.208,2.156 5.625,2.365 0.417,0.208 10 false GND1 1.448,1.188 2.667,1.417 1.219,0.229 10 false from PANEL Relay 4.708,0.156 5.813,0.365 1.104,0.208 10 false to Other Systems 4.865,1.24 5.167,1.438 0.302,0.198 10 false I12 4.865,1.031 6.167,1.49 1.302,0.458 10 false 15 4.854,2.177 5.219,2.417 0.365,0.24 10 false I10 4.917,1.99 6.219,2.448 1.302,0.458 10 false 1

PROCEDURE

1.CHECK ILLUMINATION
a.

Check if the illumination for the radio receiver assembly, steering pad switch assembly, heater control switch or others (hazard switch, transmission control switch, etc.) comes on when the light control switch is turned to the head or tail position.

Result:
Result Proceed to
Illumination comes on for all components except radio receiver assembly. A
No illumination comes on (radio receiver assembly, hazard switch, heater control switch, etc.). B




A

2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL CIRCUIT)

B

2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL CIRCUIT)
a.

Disconnect the I10 and I12 radio receiver assembly connectors.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(I12)Location & Routing

Click Connector(I12)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Radio Receiver Assembly

I12-15 (ILL+) - Body ground Ignition switch ON
Light control switch in tail or head
11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(I10)Location & Routing

Click Connector(I10)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Radio Receiver Assembly

I10-1 (GND1) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR