The telephone transceiver assembly sends a mute signal to the stereo component amplifier assembly.
The stereo component amplifier assembly controls the volume according to the mute signal from the telephone transceiver assembly.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION
When replacing the telephone transceiver assembly, make sure to replace it with a new one.
| *a | Component with harness connected (Telephone Transceiver Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I55)Location & Routingewd_type=routing;type=c;code=I55 |
||
| I55-14 (MUTE) - Body ground | Ignition switch ON Audio system playing → Emergency call mode |
2 V or higher → Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Disconnect the S22 stereo component amplifier assembly connector.
Disconnect the I55 telephone transceiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(S22,I55)Location & Routingewd_type=routing;type=c,c;code=S22,I55 Click Connector(S22)Body>No. 2 Floor Wire / Step Rear Floor Wire LH>Stereo Component Amplifier Assemblyewd_type=component;type=c;code=S22;pinno=2 |
||
| S22-2 (TMUT) - I55-14 (MUTE) | Always | Below 1 Ω |
| S22-2 (TMUT) or I55-14 (MUTE) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the I55 telephone transceiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I55)Location & Routingewd_type=routing;type=c;code=I55 |
||
| I55-14 (MUTE) - Body ground | Ignition switch ON | 2 V or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG