Each unit of the navigation system connected to the AVC-LAN (communication bus) transmits switch signals via AVC-LAN communication.
If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION
The radio receiver assembly is the master unit.
Remove the radio receiver assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio Receiver Type)>REMOVAL
| *a | Component without harness connected (Radio Receiver Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I10)Location & Routingewd_type=routing;type=c;code=I10 |
||
| I10-5 (TX1+) - I10-6 (TX1-) | Always | 60 to 80 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio Receiver Type)>REMOVAL
Disconnect the I10 radio receiver assembly connector.
Disconnect the I22 integration control sub-assembly connector.
Disconnect the I18 multi-display assembly connector.
Disconnect the I78 air conditioning control assembly (switch and volume) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I10,I22,I18,I78)Location & Routingewd_type=routing;type=c,c,c,c;code=I10,I22,I18,I78 |
||
| I10-5 (TX1+) - I22-36 (TX1+) | Always | Below 1 Ω |
| I10-6 (TX1-) - I22-35 (TX1-) | Always | Below 1 Ω |
| I10-5 (TX1+) or I22-36 (TX1+) - Body ground | Always | 10 kΩ or higher |
| I10-6 (TX1-) or I22-35 (TX1-) - Body ground | Always | 10 kΩ or higher |
| I22-18 (TX+) - I18-7 (TX+) | Always | Below 1 Ω |
| I22-40 (TX-) - I18-19 (TX-) | Always | Below 1 Ω |
| I22-18 (TX+) or I18-7 (TX+) - Body ground | Always | 10 kΩ or higher |
| I22-40 (TX-) or I18-19 (TX-) - Body ground | Always | 10 kΩ or higher |
| I22-13 (TX3+) - I78-1 (TX+) | Always | Below 1 Ω |
| I22-11 (TX3-) - I78-2 (TX-) | Always | Below 1 Ω |
| I22-13 (TX3+) or I78-2 (TX+) - Body ground | Always | 10 kΩ or higher |
| I22-11 (TX3-) or I78-2 (TX-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect and reconnect each slave unit one by one until the master unit returns to normal.
Check all slave units.
If disconnecting a slave unit causes the master unit to return to normal, the slave unit is defective and should be replaced.
Master unit return to normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio Receiver Type)>REMOVAL