| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B153A | GVIF Disconnected (from Extension Module to H/U) | GVIF disconnected (from navigation ECU assembly to radio receiver assembly) |
·
Harness or connector
·
Navigation ECU assembly
·
Radio receiver assembly |
Navigation System | A |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION
Pre-procedure1
Clear the DTCs.
Procedure1
Press the "MAP" switch and check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Disconnect the I157 radio receiver assembly connector.
Disconnect the I158 navigation ECU assembly connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I157,I158)Location & Routingewd_type=routing;type=c,c;code=I157,I158 |
||
| I157-1 (GV2-) - I158-1 (GVO-) | Always | Below 1 Ω |
| I157-2 (GV2+) - I158-2 (GVO+) | Always | Below 1 Ω |
| I157-3 (GVG2) - I158-3 (GVG1) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Replace the navigation ECU assembly with a new or known good one.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Clear the DTCs.
Procedure1
Press the "MAP" switch and check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio Receiver Type)>REMOVAL