84491 1.INSPECT PARKING SUPPORT BRAKE CANCEL SWITCH
| *a | Component without harness connected (Parking Support Brake Cancel Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I83)Location & Routingewd_type=routing;type=c;code=I83 |
||
| I83-5 (IG) - I83-2 (ECU) | Parking support brake cancel switch pushed | Below 1 Ω |
| I83-5 (IG) - I83-2 (ECU) | Parking support brake cancel switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the parking support brake cancel switch.
| *a | Component without harness connected (Parking Support Brake Cancel Switch) |
Check the illumination.
Apply battery voltage to the connector and check the illumination conditions.
| Tester Connection | Specified Condition |
|---|---|
Click Location & Routing(I83)Location & Routingewd_type=routing;type=c;code=I83 |
|
| Battery positive (+) - I83-6 (ILL+) Battery negative (-) - I83-1 (ILL-) |
LED Illuminates |
If the result is not as specified, replace the parking support brake cancel switch.