Home › Engine / Hybrid System › STOP AND START › STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY
RM38G0E _51 Engine / Hybrid System _101047 STOP AND START _0469048 STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY G

STOP AND START  STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 84470A 1.INSPECT ECO RUN CANCEL SWITCH ASSEMBLY

a.
A489121C02
1.573,0.302 1.885,0.5 0.313,0.198 2.031,1.323 2.208,1.917 2.208,1.917 2.469,1.917 true 0.865,1.885 1.104,1.885 1.104,1.885 1.375,1.323 true 1.635,0.323 2.094,0.521 0.458,0.198 10 false I82 2.521,1.844 2.979,2.042 0.458,0.198 10 false E 0.531,1.813 0.99,2.01 0.458,0.198 10 false ECU 0.083,0.063 0.542,0.26 0.458,0.198 10 false *a
*a Component without harness connected
(Eco Run Cancel Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(I82)Location & Routing

Click Connector(I82)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Eco Run Cancel Switch Assembly

I82-5 (ECU) - I82-2 (E) Eco run cancel switch assembly being pushed and held Below 1 Ω
Eco run cancel switch assembly not pushed 10 kΩ or higher


If the result is not as specified, replace the eco run cancel switch assembly.


b.
A489121C03
1.573,0.302 1.885,0.5 0.313,0.198 2.26,1.323 2.438,1.917 2.438,1.917 2.698,1.917 true 0.729,1.896 0.969,1.896 0.969,1.896 1.156,1.323 true 1.635,0.323 2.094,0.521 0.458,0.198 10 false I82 2.771,1.844 3.229,2.042 0.458,0.198 10 false ILL- 0.438,1.802 0.896,2 0.458,0.198 10 false ILL+ 0.083,0.063 0.542,0.26 0.458,0.198 10 false *a
*a Component without harness connected
(Eco Run Cancel Switch Assembly)


Apply battery voltage between the terminals of the switch, and check the illumination condition of the eco run cancel switch assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → I82-6 (ILL+)
Battery negative (-) → I82-1 (ILL-)
Illuminates


If the result is not as specified, replace the eco run cancel switch assembly.