CHECK ECM (for 1GR-FE)
The standard voltage between each pair of the ECM terminals is shown in the table below. The appropriate conditions for checking each pair of the terminals are also indicated. The result of checks should be compared with the standard voltage for each pair of the terminals as displayed in the Specified Condition column. The illustration above can be used as a reference to identify the ECM terminal locations.
| Terminal No. (Symbols) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| B2-7 (STP) - C92-81 (E1) | Stop light switch assembly signal | Brake pedal depressed | 11 to 14 V |
| Brake pedal released | 0 to 1.5 V | ||
| B2-8 (ST1-) - C92-81 (E1) | Stop light switch assembly signal | Ignition switch ON, brake pedal depressed | 0 to 1.5 V |
| Ignition switch ON, brake pedal released | 11 to 14 V |
CHECK ECM (for V35A-FTS)
The standard voltage between each pair of the ECM terminals is shown in the table below. The appropriate conditions for checking each pair of the terminals are also indicated. The result of checks should be compared with the standard voltage for each pair of the terminals as displayed in the Specified Condition column. The illustration above can be used as a reference to identify the ECM terminal locations.
| Terminal No. (Symbols) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| B1-21 (ST1-) - B1-9 (E1) | Stop light switch assembly signal | Ignition switch ON, brake pedal depressed | 0 to 1.5 V |
| Ignition switch ON, brake pedal released | 11 to 14 V | ||
| B1-22 (STP) - B1-9 (E1) | Stop light switch assembly signal | Brake pedal depressed | 11 to 14 V |
| Brake pedal released | 0 to 1.5 V |