Home › ADAS / AD › ADVANCED DRIVER ASSISTANCE SYSTEM › FRONT CAMERA SYSTEM
RM38G0E _95 ADAS / AD _100650 ADVANCED DRIVER ASSISTANCE SYSTEM _0469135 FRONT CAMERA SYSTEM C

ADVANCED DRIVER ASSISTANCE SYSTEM  FRONT CAMERA SYSTEM  U010087  Lost Communication with ECM/PCM "A" Missing Message  U010187  Lost Communication with TCM Missing Message  U012687  Lost Communication with Steering Angle Sensor Module Missing Message  U012987  Lost Communication with Brake System Control Module Missing Message  U014087  Lost Communication with Body Control Module Missing Message  


DESCRIPTION

When a malfunction is detected between various ECUs and sensors, these DTCs are stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
U010087 Lost Communication with ECM/PCM "A" Missing Message 3 seconds after the ignition switch is turned to ON, while the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the ECM and the forward recognition camera is detected for 5 seconds or more. CAN communication system Front Recognition Camera B
U010187 Lost Communication with TCM Missing Message 3 seconds after the ignition switch is turned to ON, a communication error between the TCM and the forward recognition camera is detected for approximately 5 seconds or more. CAN communication system Front Recognition Camera B
U012687 Lost Communication with Steering Angle Sensor Module Missing Message 3 seconds after the ignition switch is turned to ON, a communication error between the steering sensor and the forward recognition camera is detected for 5 seconds or more. CAN communication system Front Recognition Camera B
U012987 Lost Communication with Brake System Control Module Missing Message 3 seconds after the ignition switch is turned to ON, a communication error between the No. 2 skid control ECU (brake actuator assembly) and the forward recognition camera is detected for 5 seconds or more. CAN communication system Front Recognition Camera B
U014087 Lost Communication with Body Control Module Missing Message 3 seconds after the ignition switch is turned to ON, a communication error between the main body ECU (multiplex network body ECU) and the forward recognition camera is detected for 5 seconds or more. CAN communication system Front Recognition Camera B

PROCEDURE

1.CHECK FOR DTCs

Pre-procedure1

a.

Clear the DTCs.

Chassis > Front Recognition Camera > Clear DTCs
50002 430

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



Procedure1

c.

Check for DTCs.

Chassis > Front Recognition Camera > Trouble Codes
50001 430
Result:
Result Proceed to
CAN communication system DTC is not output A
CAN communication system DTC is output B



Post-procedure1

d.

None



A

B