When a malfunction is detected between various ECUs and sensors, these DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U010087 | Lost Communication With ECM/PCM "A" Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the ECM and the forward recognition camera is detected for approximately 1 second or more. | CAN communication system | Pre-Collision System | B |
| U010187 | Lost Communication with TCM Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the TCM and the forward recognition camera is detected for approximately 9 seconds or more. | CAN communication system | Pre-Collision System | B |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the steering sensor and the forward recognition camera is detected for approximately 1 second or more. | CAN communication system | Pre-Collision System | B |
| U012987 | Lost Communication with Brake System Control Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the No. 2 skid control ECU (brake actuator assembly) and the forward recognition camera is detected for approximately 2 seconds or more. | CAN communication system | Pre-Collision System | B |
| U118F87 | Lost Communication with Steering Actuator Control Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the power steering ECU with motor assembly and the forward recognition camera is detected for approximately 2 seconds or more. | CAN communication system | Pre-Collision System | B |
Pre-procedure1
Clear the DTCs.
Reproduce the vehicle conditions that were present when the DTCs that were noted were stored.
If the detection conditions are not met, the system cannot detect malfunctions.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING