Home › ADAS / AD › ADVANCED DRIVER ASSISTANCE SYSTEM › LANE DEPARTURE ALERT SYSTEM
RM38G0E _95 ADAS / AD _100650 ADVANCED DRIVER ASSISTANCE SYSTEM _0469139 LANE DEPARTURE ALERT SYSTEM U

ADVANCED DRIVER ASSISTANCE SYSTEM  LANE DEPARTURE ALERT SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

Some Data List values may vary significantly due to slight measurement errors, differences in the measurement environment, and changes in the vehicle over time, making it difficult to indicate clear evaluation standards. It is possible that a malfunction may be present even if measured values are within the reference range.


a.

Read the Data List according to the display on the GTS.

Chassis > Lane Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Total Distance Traveled - - - Cannot be used
Total Distance Traveled - Unit - - - Cannot be used
LDA Control Whether lane departure alert system control is permitted or not Prohibit or Permit Prohibit: Lane departure alert system control not possible
Permit: Lane departure alert system control possible
-
Turn Switch (Right) Turn signal switch (right) status ON or OFF ON: Turn signal switch on (right)
OFF: Turn signal switch off (right)
-
Turn Switch (Left) Turn signal switch (left) status ON or OFF ON: Turn signal switch on (left)
OFF: Turn signal switch off (left)
-
Vehicle Information (2WD/4WD) - - - Cannot be used
Vehicle Information (Powertrain Type) - - - Cannot be used
Not Holding Steering Wheel Judgment Status (Torque Sensor) Judgement status by torque sensor of whether hands are not on steering wheel Detected or Not Detected Detected: Judgment of hands not on steering wheel detected
Not Detected: Judgment of hands not on steering wheel not detected
-
Not Holding Steering Wheel Judgment Status (Touch Sensor) - - - Cannot be used
Selected Lane Center Distance Distance to lane center -2147483648 to 2147483520 m Actual distance from vehicle to lane center When lane center is on right side from vehicle: Displayed by a positive value
When lane center is on left side from vehicle: Displayed by a negative value
Driver Torque Input Steering Status Status of steering torque input by driver Detected or Not Detected Detected: Steering input detected
Not Detected: Steering input not detected
-
Driver Torque Cancel Steering Status Driver cancel steering input status Detected or Not Detected Detected: Cancel steering input detected
Not Detected: Cancel steering input not detected
-


ACTIVE TEST


HINT:

Using the GTS, perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Perform Active Test according to the display on the GTS.

Chassis > Lane Control > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Buzzer Sounds the LDA buzzer (meter buzzer) Start/Stop Confirm that the vehicle is stopped with the ignition switch ON.
Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display (All) Completely illuminates the multi-information display ON Confirm that the vehicle is stopped with the ignition switch ON.