When a malfunction is detected between various ECUs and sensors, these DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U010087 | Lost Communication With ECM/PCM "A" Missing Message | After 3 seconds or more have elapsed since turning the lane departure alert system on and the ignition switch to ON, while the vehicle speed is 5 km/h (3 mph) or more, a communication malfunction between the forward recognition camera and the ECM is continuously detected for 5 seconds or more | CAN communication system | Lane Control | B |
| U010187 | Lost Communication with TCM Missing Message | After 3 seconds or more have elapsed since turning the lane departure alert system on and the ignition switch to ON, while the vehicle speed is 5 km/h (3 mph) or more, a communication malfunction between the forward recognition camera and the TCM is continuously detected for 5 seconds or more | CAN communication system | Lane Control | B |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | After 3 seconds or more have elapsed since turning the lane departure alert system on and the ignition switch to ON, a communication malfunction between the forward recognition camera and the steering sensor is continuously detected for 5 seconds or more | CAN communication system | Lane Control | B |
| U012987 | Lost Communication with Brake System Control Module Missing Message | After 3 seconds or more have elapsed since turning the lane departure alert system on and the ignition switch to ON, a communication malfunction between the forward recognition camera and the No. 2 skid control ECU (brake actuator assembly) is continuously detected for 5 seconds or more | CAN communication system | Lane Control | B |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | After 3 seconds or more have elapsed since turning the lane departure alert system on and the ignition switch to ON, a communication malfunction between the forward recognition camera and the combination meter assembly is continuously detected for 50 seconds or more | CAN communication system | Lane Control | B |
Pre-procedure1
Clear the DTCs.
Reproduce the vehicle conditions that were present when the DTCs that were noted were stored.
If the detection conditions are not met, the system cannot detect malfunctions.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING